Menu Close

Can you cut OSB plywood?

Can you cut OSB plywood?

While OSB may look and feel a little different than plywood, cutting OSB is very similar to cutting plywood and any number of saws can be used. A table saw is best when making multiple straight cuts on many sheets. Turn on the table saw and feed the board through. Make sure to go slow so the cut is made straight.

Can you use a router on OSB?

, OSB is murder on router bits. As others have said, this is NOT a job for a trim router. I prefer my Sawzall for this job. To get the broken bit out you should be able to completely remove the collet and then push the shank of the router bit out of it using a punch, small screwdriver, etc.

Why is OSB cheaper than plywood?

Plywood is the more expensive option to build with than OSB. The material tends to be thicker and needs to be made to more exacting standards, which increases costs. A 4×8-foot sheet of construction-grade plywood costs roughly $10 a sheet, while the same size sheet of OSB costs only $6 a sheet.

What happens if you cut an edge of OSB?

Bits and pieces may fly into the air. The edges of the cut may be jagged and rough, so smooth them over with sandpaper or even a block plane. OSB manufacturers coat their product with a waterproof sealant after it is baked. Cutting open an edge exposes the core of the board to moisture and can weaken it.

Can a table saw be used to cut OSB?

While OSB may look and feel a little different than plywood, cutting OSB is very similar to cutting plywood and any number of saws can be used. A table saw is best when making multiple straight cuts on many sheets. Measure the area where the OSB will go and determine the size cuts that will need to be made on each sheet.

Do you need to cut OSB before you waterproof it?

Therefore, you will need to make sure your OSB is cut into the pieces you will need before you add your waterproofing so these edges can be protected. Measure, mark, and cut all the pieces you need, and set them aside on the tarp. You don’t want grass or dirt to get in your waterproofing either. Save a scrap piece of OSB at this time as well.

What to use to smooth edges of OSB?

Adjust the guide fences and blade guard on your saw as applicable. Because OSB is made with large particles it is subject to “tear-out.” Bits and pieces may fly into the air. The edges of the cut may be jagged and rough, so smooth them over with sandpaper or even a block plane.