Menu Close

Can you use a wooden dowel as a curtain rod?

Can you use a wooden dowel as a curtain rod?

By styling wooden dowels to look like copper rods, the DIY curtain rods were so inexpensive (just $12 apiece!) that we had money left over to craft statement-making tiebacks to match. Measure your window, then cut the 1-inch wooden dowel to a length at least 5 inches longer than your window is wide.

How do you hang a curtain rod from a dowel?

Find and mark the center of one end of the dowel. Drill a 3/16 inch hole one inch deep at the center mark. Use pliers to screw one end of the dowel screw into the dowel, then screw the other dowel onto that. Sand and apply clear finish* to dowel rods.

How do you hang a wooden dowel rod?

  1. Step 1: Measure the Walls. Measure the depth of the closet on both sides, and subtract 1/4 inch.
  2. Step 2: Drill Holes. Measure the size of the dowel.
  3. Step 3: Find the Studs.
  4. Step 4: Cut the Dowel.
  5. Step 5: Install the Stretchers.
  6. Step 6: Level and Mark.
  7. Step 7: Finish the Job.
  8. Fit end caps over both ends of the dowel.

How do you secure a wooden dowel?

Using a one-inch Forstner bit, drill 1/4 inch down into the center of a 5-inch diameter round of wood. Use wood glue to secure the dowel in place. To top it with a handle, drill a small hole all the way through the dowel, about one inch below the top.

How do you attach a dowel to the wall?

Predrill a hole in center of other end of each dowel. Using pliers, screw dowel screws into holes. If possible, mount dowels directly into studs in your wall, using level to ensure they go in straight. If not, use appropriate anchors for your type of wall, then mount dowels.

What sizes do wooden dowels come in?

Pre-cut dowels are usually either 6mm (¼”) wide and 30mm (13/16″) long, or 8mm (5/16″) or 10mm (3/8″) wide and 40mm (19/16″) long. When buying specific equipment for dowelling, such as drill bits, drill stops and centre points, these sizes are considered standard.

How do you extend a wooden curtain rod?

  1. Step 1: Purchase the Doweling. Find wooden doweling that has the same diameter as the rod you want to extend.
  2. Step 2: Prepare the Doweling.
  3. Step 3: Insert the Doweling.
  4. Step 4: Install a Double-Ended Screw.
  5. Step 5: Connect the Rods.

How do you make dowel rods out of wood?

How do you paint dowel rods for curtains?

Paint the dowel rod and finials with a finish coat of latex paint. Choose the color that most goes with your curtains. For a more durable surface, apply two coats. Make an “X” on the end of the dowel rod to locate the center. Draw two lines, starting on opposite sides of the rod end face using a small straight edge.

How do you make a curtain rod holder?

You can also custom make wooden curtain rod holders by using pre-cut wooden corbels. Use a hole saw to cut the notches for the dowel rod, mount the corbels onto the wall with toggle bolts, or screws if you are going into studs, and push the rod through the holes.

How do you hang dowel curtains on Wall?

Measure and mark where you want to hang your curtains. Pre-screw the drywall anchor onto the screw (because the dowel screw is slightly bigger than the screw that comes with the drywall anchor). Drill a 5/16” hole in the wall where you want the bracket to go; install the drywall anchor.

adplus-dvertising